|
Post by allan on Nov 10, 2020 2:58:07 GMT
Hi folks, I'm very happy to finally being here. I've been building a arduino midi drum set for 2-3 years by now, and after a lot of research and try-error I've got my setup to work "properly". The "setup" is as this> arduino sends data to windows; hairless midi captures it and send to loopmidi, wich is then heard by PS. I mapped the drums with PS profiler, and it apparently installed it correctly: I can play a few notes in the beginning of the song, but just a few seconds, because after that the drums don't trigger any signal (though hairlessmidi keeps sending data to loopmidi). If I restart the song I'm able to play a few seconds again, and then it kind of "disconnects" it again. Any thoughts on how to make it work properly?
Thanks a lot.
|
|
|
Post by vandorb12 on Nov 13, 2020 2:53:50 GMT
This is well out of the standard support wheelhouse. You made it, you should spend the time fixing it.
Try the unofficial discord, other folks with arduino setups like yours are more active there.
|
|
|
Post by limor on Nov 25, 2020 20:33:59 GMT
check this post www.plzi.com/aanta/tapdrumtrigger.aspthey do serial emulation on one of the pins so you can flash the arduino while the serial emulator talks with hairles+loopmidi you may need to get a usb-serial adapter ($3 from china) for this serial emulation pin to present itself as second serial device in windows
|
|